EtroVISION Video Server User Manual

1111111111111111111Page 1 of 50 1 041 091107 Disclaimer © 2007 Etrovision Technology. All rights reserved. Etro

04 10 - Brown line : DO + - Red line : DO - FACTORY SETTING - INITIAL IP ADDRESS IP Address : 192.168.1.2 Gateway : 192.168.1.1 NETWORK DOMAIN Chan

04 11 Click scan to automatically find online EV315X on the network domain Press Scan button to list the IP and MAC address table. To refresh, pres

04 12 Double click Change any settings you want to make and make sure you have correct values in all fields. Click Apply. Within 10 seconds, t

04 13 7. ACCESS VIDEO SERVER BROWSER ¾ Open IE browser ¾ Type IP address of video server that you found on EtroScan™ software. For ex. default IP

04 14 INITIAL USERNAME & PASSWORD Administrator ¾ Default ID/Password = root/pass. ¾ Only password is changeable for root account. ¾ Full ac

04 15 1. Notice top right corner of viewing page has a toggle button to take you between web configuration page & viewing page. Always click tha

04 16 is not an error. ¾ P/T/Z controls (will need PTZ controller)  Preset: preset point set & go defined preset point  Focus: adjust ca

04 17 8. WEB INTERFACE SETTINGS EV3151 / EV3151A built-in web interface offers more advanced settings. On the main viewing page, click icon located o

04 18 NOTE Remember to press “OK” after you have changed settings in a particular settings page which has “OK” button. After few seconds, you can see

04 19 ¾ Always click “OK” to save changes in a particular page. ¾ Reboot is required and will be automatically triggered after you press “OK”. Wait

About this document Applied models: z EV3151 z EV3151 A This user manual is intended for administrator and/or user of Etrovision EV3151 & EV315

04 20 Note: Always use EtroScan™ to find the MAC address after reboot and double check the IP address is correct. If IP was changed in web configurat

04 21 VIDEO Stream 1 VIDEO SETTINGS ¾ Stream Port  Stream 1 port value setting ¾ Stream Protocol  TCP/UDP(RTP) selectable  When UDP selected

04 22 ¾ Bit rate Type  Constant and Variable bit rates control allows flexibility in choosing how much bandwidth is available on network and quali

04 23 For higher bit rates and resolution, the client limit is much lower and vice versa. ¾ Maximum number of clients can be restricted depending o

04 24 COLOR SETTINGS Fine adjustments to video quality can be made using more detailed settings as shown below. BRIGHTNESS Adjusts the image on a

04 25 VIDEO PREVIEW Preview makes choices easier when tuning video settings for specific locations. By clicking the View Video button, you can see th

04 26 Actions supported by EV3151 1. PTZ Preset 2. E-mail Notification 3. Record (Record to Local SD Card) PTZ Preset Email Notification Recor

04 27 EVENTS HANDLED Digital Input Can choose sensor type either “Normal Open” or “Normal Close” Motion Detection If motion is detected on the areas

04 28 When system detect system power loss, an event will be triggered ACTIONS TRIGGERED Digital Output Can active digital output. PTZ Preset PTZ se

04 29 DATE & TIME ¾ Date and time settings can be synchronized with PC directly by clicking “Client PC time” check box. Click “OK” after you

3333333333333333333Page 3 of 50 3 043 TABLE OF CONTENTS 1. PRODUCT OVERVIEW...

04 30 OSD Channel name can be shown/hidden by the channel name “Enable” checkbox. It can be manually typed in the “Channel name” text box and chang

04 31 can be chosen. ¾ Channel ID  Give address value - default is zero. ¾ Baud rate / Data bits / Parity / Stop bits  Depending on the protoc

04 32 DDNS is the function that maps an IP address to a host name. If EV3151 / EV3151A are set to dynamic IP address, the host name by DDNS (Dynamic

04 33 An e-mail notification & FTP upload service offered by EV3151 / EV3151A notifies events or uploads snapshots to a remote FTP server. E-MAI

04 34 FTP SETTINGS Fill in the details of remote FTP server, port number and user name, password. TRIGGER SETUP 091107

04 35 Three different types of EVENTS can be configured. Digital INPUT Can be Normal OPEN (N.O) or Normal Close (N.C) Choose based on the type of

04 36 ¾ Detection Area  Enable/Disable Motion Detection by click check box; administrator can self-configure up to 3 detection areas. Click are

04 37  Defines sensitivity of the motion detection. The range of the value is -10 to 10. **Lower sensitivity value, higher sensitivity level Video

04 38 SD CARD Only EV3130A/AW support SD card interface, system will show current SD card capacity information if SD card is plugged in socket well.

04 39 Note: Following SD card are fully evaluated in Etrovision engineering lab for compatibility test SD 1.1 z Sandisk 512MB z Transcend 1GB z AD

4444444444444444444Page 4 of 50 4 044 091107 COLOR SETTINGS ...

04 40 For each account, guest permissions can be turned ON/OFF. Any time, an account’s settings can be modified by pressing the related button. Ad

04 41 ¾ Security Level  HIGH  ONLY LAN connections are allowed.  MEDIUM  Video and audio connections from any location and settings from L

04 42 MAINTENANCE 091107 Language • Default settings are in English. Another choices are : o Traditional Chinese o Deutsch o Simplified Chinese

04 43 9. FACTORY DEFAULT After a confirmation dialog box, clicking OK button, will load default settings and do a reboot. You will see the reboot c

04 44 12. ETROLINK™ Config Port - FIRST TIME EXPERIENCE If video server has to be quickly configured or has to be set to factory default settings, E

04 45 NO SOFTWARE INSTALLATION REQUIRED There is no installation or setup of any software for Windows XP/2000 platforms. STEPS FOR USING ETROLINK™

04 46 5. Double click Config Wizard. You will see a screen as follows. You will be asked for password. Earlier, if you have never changed the pas

04 47 If you would wish to change network settings of either STATIC / DHCP / PPPoE If you would want to setup DDNS, please click on the same for det

04 48 network configuration page. Click next to proceed. Clicking next will show that settings are saved. You can click finish if you are done or go

04 49  Connect speaker and active microphone to Audio Out/In. WHAT IF QUICKCONFIG DOES NOT AUTORUN? In some PC, after connecting USB cable with

04 5 1. PRODUCT OVERVIEW EV3151 & EV3151A are stand-alone video/audio streaming servers designed for professional IP surveillance applications. W

04 50 www.etrovision.com TEL:+886-2-26551518 2F, Block C, Nan Kang Software Park, 19-5 San-chung Rd., Nan Kang Distri

04 6 making it the only digital surveillance product in the market with proprietary design for "Ease-of-use", "Reliability", and

04 7 3. BEFORE YOU INSTALL SOFTWARE 9 PC running Microsoft Windows 2000 or Windows XP is only capable of running EtroStation™3.0 software. 9 PLEASE

04 8 EV3151A Audio In/Out POWER LED RJ-45 socket WLAN Dongle Socket Etrolink config port Video IN 091107 miniDIN (DI/DO/485) Power Jack 6.

04 9 CONNECTING TO NETWORK Connect a standard CAT5 Ethernet cable to R45 socket on EV3151 / EV3151A and connect other end to your network hub/switch.